IICHID(4)              FreeBSD Kernel Interfaces Manual              IICHID(4)

NAME

     iichid - I2C HID transport driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device iichid

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           iichid_load="YES"

DESCRIPTION

     The iichid driver provides a interface to I2C Human Interface Devices
     (HIDs).

SYSCTL VARIABLES

     Next parameters are available as sysctl(8) variables.  Debug parameter is
     available as loader(8) tunable as well.

     dev.iichid.*.sampling_rate_fast
             Active sampling rate in num/second (for sampling mode).

     dev.iichid.*.sampling_rate_slow
             Idle sampling rate in num/second (for sampling mode).

     dev.iichid.*.sampling_hysteresis
             Number of missing samples before enabling of slow mode (for
             sampling mode).

     hw.iichid.debug
             Debug output level, where 0 is debugging disabled and larger
             values increase debug message verbosity.  Default is 0.

SEE ALSO

     ig4(4)

BUGS

     The iichid does not support GPIO interrupts yet.  In that case iichid
     enables sampling mode with periodic polling of hardware by driver means.
     See dev.iichid.*.sampling_* sysctl(8) variables for tuning of sampling
     parameters.

HISTORY

     The iichid driver first appeared in FreeBSD 13.0.

AUTHORS

     The iichid driver was written by Marc Priggemeyer
     <marc.priggemeyer@gmail.com> and Vladimir Kondratyev <wulf@FreeBSD.org>.

     This manual page was written by Vladimir Kondratyev <wulf@FreeBSD.org>.

FreeBSD 15.1-STABLE-HBSD      September 21, 2020                     IICHID(4)